|Condition:||New||Type:||Straightener & Uncoiler|
|Use:||Think coil||Place of Origin:||Guangdong,China|
|Weight:||800kg||Certification:||CE and ISO|
|Warranty:||1 Year||Material thickness:||0.1-0.6mm|
|Straightener roller:||Upper10/lower11||Packaging details:||Wooden box|
|Supply Ability:||1 Set/Sets per Month||Delivery detail:||telephone conversation|
|After-sales Service Provided:||Field installation, commissioning and training||Port:||Shenzhen/guangzhou port|
1. The power supply voltage of the uncoiler cum straightener machine is AC three phase 380V. when wiring at the customer's factory, it must be confirmed that the power supply voltage matches the voltage required by the machine, and there is no phase loss, poor contact, etc. to avoid damage. for factories with self power generation capabilities, it should be ensured that a voltage stabilization protection device is connected to avoid damage to the uncoiler cum straightener due to excessive voltage.
2. Before turning on the power to test the machine, check whether the feeding direction is correct.
3. When loading the coil, first adjust the uncoiler machine for handle counterclockwise to make the diameter of the supporting plate smaller than the inner diameter of the coil, and then install the coil. adjust the rocker clockwise to make the supporting plate open and tighten the inner diameter of the material, remove the rocker and put on the A type iron. do not clamp the material too tightly or loosely.
4. Turn on the power switch, slow down the speed, relax the feeding handle, and open the release lever, so that the material smoothly enters the straightening head to the discharge wheel. stop and lower the release lever, tighten the feed handle and the discharge handle. tighten the handle. adjust the stopper wheel. the blocking wheel should not be too tight. generally, it can be 3-5mm wider than the material. turn on and adjust the flat handle until it is level.
5. Adjust the distance between the uncoiler and straightener machine to the feeder. adjust the distance appropriately according to the speed of the punch and the length of the feeder. the straightened material should be able to enter the feeder and the mold smoothly.
6. Adjust the distance of the 24V induction frame, properly adjust the brake wheel on the left side of the uncoiler and straightener to make the material discharge smoothly, and do not make the material inertia too large, but it should not be too tight so as not to affect the normal leveling. to meet the normal work of the feeder is appropriate.
|GLM Thin Coil Uncoiler Cum Straightener Machine Specification|
1. The uncoiler and straightener machine have undergone strict factory inspection before leaving the factory, and the inverter parameters have been set. If the customer has special needs and needs to change the inverter parameters, our company's professional and technical personnel should perform this operating.
2. Be sure to have a ground wire when wiring the machine to prevent electric shock and leakage.