|Condition:||New||Type:||Straightener & Uncoiler|
|Use:||Think coil||Place of Origin:||Guangdong,China|
|Weight:||420kg||Certification:||CE and ISO|
|Warranty:||1 Year||Material thickness:||0.1-0.6mm|
|Straightener roller:||Upper10/lower11||Packaging details:||Wooden box|
|Supply Ability:||1 Set/Sets per Month||Delivery detail:||telephone conversation|
|After-sales Service Provided:||Field installation, commissioning and training||Port:||Shenzhen/guangzhou port|
Flip up device:
1. This device is used when cleaning the straightener roller.
2. Before opening, the head lock pin must be opened, and then the head of the control panel is opened.
3. After the wipe is completed, you need to pay attention to whether the gears engage with each other when you close it. If you don’t need to flip up the straightening head and adjust it to the gear by the inching method, be careful not to use the front and back when the straightening head is put down turn or automatically engage the gears, otherwise it will cause a break between the drum and the gears.
4. Install the cylinder, remove it when not in use, and turn the switch to the middle.
|GLM Thin Coil Uncoiler Cum Straightener Machine Specification|
1. When leaving the factory, after calibration by our company, the scale of the small hand is 5 and the large hand is 0. at this time, the upper and lower rollers are on the same horizontal line, and the large hand is rotated once, and the small hand scale is increased by 1.
2. Graduation essentials: 5mm + material thickness-slightly adjusted (appropriately adjusted according to the rigidity and thickness of the material.) then adjust according to the actual straightening effect and refer to the introduction of each department. after adjusting it, you can copy the data. at the same time, it can be directly used for reference. pay attention but do not over adjust the pressing force, and sometimes adjust and relax according to the material characteristics. excessive adjustment of the pressing force will not only cause material deformation, but in serious cases, it will cause machine damage.
3. If the handwheel needs to be adjusted down, in order to overcome the thread pitch at this time, the handwheel needs to be adjusted first and then pressed down. for example: the dial scale is 5mm, and it needs to be adjusted to 4mm (at this time, it needs to be adjusted up to 4.5mm, and then press down to 4mm).