Coil Feeder

How to adjust each part of Metal Coil Feeder

1. Adjustment of feeding height:

a. In order to correspond to the height of the stamping device, the feeding height of the leveling feeder must be adjusted

b. The feeding height adjustment position diagram of Dongguan Jieda Machinery Metal Coil Feeder is shown:

c. When adjusting, first loosen the 4 locking bolts on the left and right sides of the leveling feeder, and then press the machine up or machine down button on the operation panel to adjust the feeding height at will

d. After adjustment, tighten the bolts

e. Be sure to loosen the 4 locking bolts on the left and right sides before pressing the buttons on the operation panel

How to adjust each part of Metal Coil Feeder

2. Adjustment of the entrance width roller:

a. Open the entrance roller in the Metal Coil Feeder manual operation mode

b. The adjustment position of the entrance width roller wheel is as shown in the figure:

c. Turn the hand wheel front and rear stop wheels to move closer to the middle material at the same time, and the distance between the front and back two sets of stop wheels should be appropriately wider than the material

d. After adjustment, the material must pass through the center of the mold, and the feeder and the material must be parallel


3. Adjustment of correction amount:

a. The material can be leveled when the coil passes between the upper and lower leveling rollers. Dongguan Jieda mechanical punch three-in-one NC servo feeder defines the degree of opening of the upper and lower leveling rollers as the correction amount, and the size of the correction affects the machine Leveling effect on the material

b. The adjustment position of the correction amount of the three-in-one NC servo feeder of Dongguan Jieda Mechanical Punch is as shown:

c. The size of the correction is comprehensively adjusted according to the actual conditions such as material thickness, material material, material width, material deformation, etc.

d. When the correction amount is adjusted properly, the material will be squeezed straight out from the discharge port

e. When adjusting the correction amount, please make the correction amount of the inlet port less than the correction amount of the discharge port

f. When adjusting, please operate the feeding servo motor forward and reverse manually in the three-in-one NC servo feeder of Dongguan Jieda Machinery Punch Press, and repeat the adjustment until the correction effect is satisfactory.


4. Adjustment of the pressure on the discharge wheel, that is, the feed wheel:

a. Adjust the pressure of the feeding wheel according to the different materials passed

b. Dongguan Jieda Machinery Punch Metal Coil Feeder feed wheel pressure adjustment position as shown:

c. Pull out the adjustment knob (orange mark is leaking out) during adjustment, and then turn the adjustment knob to adjust the pressure of the discharge roller. Twist clockwise, the pressure of the roller will be strengthened, twist counterclockwise, the roller The pressure will be weakened

d. When the adjustment is completed, push the adjustment knob inward to lock the adjustment knob (the orange mark disappears)

e. When the material slips and cannot be fed correctly, the most likely cause is insufficient pressure on the three-in-one NC servo feeder of the punch press. In addition, if the material has rolling traces, it is caused by excessive pressure.


TAGS:Metal Coil Feeder

Related Products

Copyright © 2006 - 2021 Dongguan Jieda Machinery Co.,Ltd Servo Feeder Machine coil feeder line