Coil Feeder

The adjustment method of each part of the press three-in-one NC servo Coil Feeder Line

1. Adjustment of feeding height:

a. In order to correspond to the height of the stamping device, the feeding height of the leveling Coil Feeder Line must be adjusted

b. The feeding height adjustment position of the three-in-one NC servo Coil Feeder Line of Dongguan Jeda Machinery Punch is shown in the figure:

c. When adjusting, first loosen the 4 locking bolts on the left and right sides of the leveling Coil Feeder Line, and then press the machine up or machine down button on the operation panel to adjust the feeding height at will

d. After adjustment, tighten the bolts

e. Be sure to loosen the 4 locking bolts on the left and right sides before pressing the buttons on the operation panel

2. Adjustment of the entrance width roller:

b. The adjustment position of the entrance width roller wheel is as shown in the figure:

c. Rotate the hand wheel and move the front and rear stop wheels to the middle material at the same time. The distance between the front and back two sets of stop wheels should be appropriately wider than the material.

d. After adjustment, the material must pass through the center of the mold, and the Coil Feeder Line must be parallel to the material

3. Adjustment of correction amount:

a. The material can be leveled when the coil passes between the upper and lower leveling rollers. Dongguan Jieda mechanical punch three-in-one NC servo Coil Feeder Line defines the degree of opening of the upper and lower leveling rollers as the correction amount, and the magnitude of the correction amount affects The leveling effect of the machine on the material

b. The adjustment position of the correction amount of the three-in-one NC servo Coil Feeder Line of Dongguan Jieda mechanical punch is as shown:

c. The size of the correction is comprehensively adjusted according to the actual conditions such as material thickness, material material, material width, material deformation, etc.

d. When the correction amount is adjusted properly, the material will be squeezed straight out from the discharge port

f. When adjusting, please operate the feed servo motor forward and reverse in the three-in-one NC servo Coil Feeder Line of Dongguan Jieda Machinery Punch, and repeat the adjustment until the correction effect is satisfactory.The adjustment method of each part of the press three-in-one NC servo Coil Feeder Line

4. Adjustment of the pressure on the discharge wheel, that is, the feed wheel:

b. Dongguan Jieda Machinery Punch Three-in-One NC Servo Coil Feeder Line feeding wheel pressure adjustment position as shown:

c. Pull out the adjustment knob (orange mark is leaking out) during adjustment, and then turn the adjustment knob to adjust the pressure of the discharge roller. Twist clockwise, the pressure of the roller will be strengthened. The pressure will be weakened

d. When the adjustment is completed, push the adjustment knob inward to lock the adjustment knob (the orange mark disappears)

e. When the material slips and cannot be fed correctly, it is likely that the pressure is not enough for the three-in-one NC servo Coil Feeder Line of the punch press. In addition, if the material has rolling traces, it is caused by excessive pressure.


TAGS:Coil Feeder Line NC servo Coil Feeder

Related Products

Copyright © 2006 - 2021 Dongguan Jieda Machinery Co.,Ltd Servo Feeder Machine coil feeder line